Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
osenga

fdt hydro lifts

Recommended Posts

osenga
Well pulled out the 3 round tank hydro lifts all on the bench today. I just ran the pump off my drill. So here is the question.2 of them when the rams were maxed at either direction they would bogg my drill down. The other one not so much at all . This is the only reason for asking here. was really wanting to know if the suare tank one worked but drill chuck not big enough to test it

Share this post


Link to post
Share on other sites
perry
quote:
Originally posted by BLT
I would go with the first two. I don't think the drill had enough uumph to run the pump past relief, which should be a real good sign.
i am thinking that too. you can hear noise when they reach thier max lift when mounted on a tractor. it is a good idea to replace the cylinder O-rings while thier out. another good thing is to install the hydro lift and raise the rear lift tube. put a 3-4ft pipe in there and hang a engine block or something over night and see if it sag's. then put the tractor all back together if it's good.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×