Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Guest

7117H electrical

Recommended Posts

Guest
The mower belt slipped and got caught up in the pully. It shut off the engine and now it's like there is no battery in it. Not even the lights will work. I changed the circuit breaker and had the solenoid tested. Now when i try to connect the battery,it sparks. I must have crossed a wire somewhere. I have the positive cable and a jumper to the circuit breaker on one post of the solenoid and the starter wire on th other post. There is also a wire connected to a small post on the solenoid that is connected to the nuetral position. Any help on this would be appreciated.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    1. Trevor Hostetter
      Trevor Hostetter
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×