Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
landlord2110

Deck Arbor

Recommended Posts

PhanDad

The pulley comes off the top. There are many parts. Open it up and see what needs replacing. Bearings for sure and it looks the the top of the shaft is shot Where the pulley sits. Sometimes new whole arbor assemblies are available on eBay. Here's the repair instructions:

pgC6b.jpg

pgC7b.jpg

pgC6b.jpg.5c4ba2d840f726b0f6ea89d5bc1bcea8.jpg

pgC7b.jpg.038e70b23368c15edebc64914609ab3d.jpg

Share this post


Link to post
Share on other sites
JimDk

Did you see the set screw in the bottom of the pulley groove? They get filled with crud and are hard to see. Remove the set screw and drive or press the shaft out of the pulley. I slide a couple of flat steel pieces under the pulley and press it off. I have had to heat the pulley hub to both loosen the set screw and remove the pulley from the shaft. Not a fun job.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×