powersrp Posted June 20, 2014 Posted June 20, 2014 New owner 7016, front pto was not releasing completely, after looking at the linkage and realizing it had been rerouted under the starter . I rerouted over the starter after many hours of bending , I now have the correct movement but the lever doesn't want to stay in the disengaged position: any ideas? Also the drive side of pto has less than an 1/8 of material left, is that suffecient?
powersrp Posted June 22, 2014 Author Posted June 22, 2014 Thx for the replies guys, so I guess my front pto drive pulley has sum years left to it, that's a relief. I got the control rod bent the correct way finally, also put a nylon washer on the pto lever outside tbe frame to take up sum lever slop, all is good now.
Recommended Posts