Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
curlett

snow plow part dimensions needed

Recommended Posts

curlett

IMG_2014110223445.jpg

IMG_20141102335.jpg

I need to make the angle adjusting rod and small fork that goes to a 46 inch snow plow for my 7016. (#8 and #20 in the pictures) could someone take a few pictures of this with some measurements to give me something to go off of. Thanks

IMG_2014110223445.jpg.48a760e2878fffadc01e7b05b4e84a90.jpg

IMG_20141102335.jpg.57f4d462891a111ec51e646364105564.jpg

Share this post


Link to post
Share on other sites
ReedS

The ends of an FDT steering shaft are the same as the OE rod end and the swivel, need to weld a short piece of tube on one and the other on the end of the control rod. You'll need a 4' length of 7/16" rod for the control rod. I don't have the measurements handy right now but can get them.

Share this post


Link to post
Share on other sites
914-allis

I am also making the rod and bracket for my snow plow and I threaded the end of the rod and used two locking nuts to hold a bracket that is 1 1/2x3/4x1 1/2 in place. I driled a 5/16 hole in the bracket and placed it over the 5/16 pin on the plow and it works very nice.No welding needed.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×