Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

snow plow part dimensions needed


curlett

Recommended Posts

IMG_2014110223445.jpg

IMG_20141102335.jpg

I need to make the angle adjusting rod and small fork that goes to a 46 inch snow plow for my 7016. (#8 and #20 in the pictures) could someone take a few pictures of this with some measurements to give me something to go off of. Thanks

IMG_2014110223445.jpg.48a760e2878fffadc01e7b05b4e84a90.jpg

IMG_20141102335.jpg.57f4d462891a111ec51e646364105564.jpg

Link to comment
Share on other sites

The ends of an FDT steering shaft are the same as the OE rod end and the swivel, need to weld a short piece of tube on one and the other on the end of the control rod. You'll need a 4' length of 7/16" rod for the control rod. I don't have the measurements handy right now but can get them.

Link to comment
Share on other sites

I am also making the rod and bracket for my snow plow and I threaded the end of the rod and used two locking nuts to hold a bracket that is 1 1/2x3/4x1 1/2 in place. I driled a 5/16 hole in the bracket and placed it over the 5/16 pin on the plow and it works very nice.No welding needed.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...