powermax tiller

[mech123 0]

does anyone actually have a powermax 3 point tiller?? pics?? im in the process of making a pto driveshaft and was wondering about the pto shaft alignment as well as the spline count... I see the tractor is 15

[720nut 4,225]

Chris, I have one but I'm terrible at trying to post pics. Try this site I was told by another tractor owner that they have the input shafts and can make the entire shaft if need be

www.weasler.com

[Talntedmrgreen 1,978]

Weasler is one of the primary manufacturers of shafts, ends and joints. With input from another owner a shaft should be real easy to put together. I did so for my legacy and sweepster broom, from.parts on the shelf at TSC.

[mech123 0]

I work on commercial lawn and garden equipment.. fyi the walker pto driveshaft is a 15 spline... slides in perfect... thanks for the replies... weasler it is

[isetta 50]

For what it's worth here's a pic from the web showing installed tiller and shaft. Somebody out there must have one that could be measured for length. If you don't find the info you need let me know, mine is still in California

[phillobbezoo 139]

I could email you pics tomorrow evening if you still want them, I can't post them on the web site with my phone

[720nut 4,225]

Chris will have wife email you pics this evening

[isetta 50]

Posting pics courtesy of 720nut Lloyd

[720nut 4,225]

Sorry sbout the blank tape, don't know what happened. If you need measurements email or PM me I'll get them. looking at these pics I realize I need to restore my tiller looks bad

[isetta 50]

I end up emailing pics to myself from my phone so I can access in my computer and post them here

quote:Originally posted by phillobbezoo

I could email you pics tomorrow evening if you still want them, I can't post them on the web site with my phone

---

id="quote">

id="quote">

[mech123 0]

Thanks everyone for the posts

[720nut 4,225]

Guys know this is an old post but I'm in need of a male input shaft for my 620 Danco bush hog. anyone have the Weasler # for shaft? I've had a vibration since I bought it ,today finally figured out why for some reason PO rewelded it and didn't get it square