Hydraulic motors

[Johnrenk 40]

Trying to find specks for Skag mower hydraulic motors that turn the wheels. RPM HP, . Have a project in mind to run snow blower. Would I still need belting for proper RPM or would just the motor be sufficient?

[BLT 718]

Here is a book from Eaton on hydraulic motors for starts. Keep in mind that snow blowing, like cutting grass, requires speed and HP, not low end torque. There would have to be a speed reduction of sorts between engine speed and fan speed. As an example, my single stage auger impeller spins roughly 600 rpm to 3600 rpm engine speed.

http://www.eaton.com/ecm/groups/public/@pub/@eaton/@hyd/documents/content/pll_1346.pdf

[Johnrenk 40]

Thank you for the information, printed material and will look it over. Have thought about the RPM of the wheel motors thanks for the RPM of your blower. Hoping I can find two stage will only have to think about the fan RPM. Project still on the table at this time I do have the hydraulic components, they were a free-bee