Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Transmission rebuild question


jsarro

Recommended Posts

I am putting back together 2 variable speed manual transmissions.I just want to make sure I have the appropriate order of parts on the input pulley shaft.In particular, the relationship and orientation between the end hat washers and the retaining rings, is this correct on both ends of the shaft?Please see pictures below.

11142015 020.jpg

11142015 021.jpg

11142015 022.jpg

11142015 023.jpg

Thank You

 

Edited by PhanDad
removed extra pics
Link to comment
Share on other sites

Thank you Bill.

I have been referencing the manual, and agree.

The schematic in the large frame manual was easier to see the orientation of the hat washers, but the parts blow out from Jack's small engine was not as clear.

I just wanted a second look and opinion before I close these two transmissions back up with new seals.

Thanks

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...