Flywheel magnets

[faluppa 0]

Has anyone ever used to put a inside magnet on a flywheel - I broke one free some how while cleaning the flywheel off of my K301. I kept it the same direction so the polarity is correct and I was thinking about using a Gorilla 2 part epoxy to re bond it. Any feed back is welcome.

[Brettw 1,129]

I would think epoxy would work. Just make sure the surfaces are clean as can be. I would look to make sure the epoxy is capable of hadling some heat however.

[PhanDad 3,616]

Per Al:

I typically use 2000 ob epoxy....

From this post:

http://www.simpletractors.com/club2/topic.asp?ARCHIVE=true&TOPIC_ID=122304&SearchTerms=flywheel,magnet

[wwbragg 537]

I would use JB Weld - - but they are all probably about the same ---