Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
bigdog46

Install Kohler Command 14 Pro into Simplicity

Recommended Posts

bigdog46

Has anyone installed a Kohler Command Pro 14 engine into a Simplicity or Allis Chalmers?  I was wondering if the height from center of crank to base was the same as the Kohler K321?  Will holes in tractor accommodate the base mounting holes in the engine?  Also will the adaptor for the Command twin cylinder engines work on the Command Pro 14?  Any information you can provide will be greatly appreciated.  Thanks.

Share this post


Link to post
Share on other sites
MikeES

You can go on line at Kohler and pick up the information also.  The K321 is 6.125" (155.7) base to CL of crankshaft.  The base bolt holes are 6.25 cl front to back and 4.91 center to right and 5.72 center to left bolt hole.

Share this post


Link to post
Share on other sites
Mike_H
8 hours ago, bigdog46 said:

I sent a request to join the group in my wife's name (Rita Bowman) since I am not on Facebook.  Can you get me into the group?  Thanks. Gary Bowman

 

No, unfortunately I can't.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • GrincheyOne
    • rokon2813
    • RAC
    • dhoadley
    • Mine19821
  • Today's Birthdays

    1. Trevor Hostetter
      Trevor Hostetter
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×