Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

DanaD

Need measurement for 1st gen Legacy repower

Recommended Posts

DanaD

I am repowering an old Legacy (Massey version) diesel tractor with a Kohler Command. I'll need to fab an engine mounting plate and would like to get it at the stock height so the factory PTO belt size will work. Hoping someone can post the measurement for the distance from the PTO clutch bolt center to the top or center of the PTO pulley. I have also been looking for a driveshaft from a gas model but have had no luck. I may have to lengthen the Sunstar shaft I have on hand, it's at least 2 inches too short.

I know some might cringe at going from oil burner to gas but original engine was trashed and too expensive to repair or replace. I have a low hour Kohler ready to drop in.

Thanks

Dana in TN

Edited by DanaD

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Who's Online (See full list)

    • macallis180
    • s_stephen
    • PhanDad
    • bud119195
    • MARK (LI)
    • littlefan
    • rbstuartjr
  • Today's Birthdays

    1. jworth
      jworth
      (62 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      Paul
       
      · 9 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts

×