Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Horvik

BGB Parts Inquiry

Recommended Posts

DaveTenney

The needle bearings are probably Timken BH412

I'm not sure what BGB is in that tractor. If you take out the bearings and measure them it will be pretty easy to find replacements.

A good bearing house can also help you.

Here is a link to a place near me that can find just about anything.

https://www.akronbearing.com/

I have had good success with chinese bearings. Never had a failure.

  • Like 1

Share this post


Link to post
Share on other sites
CarlH

Does anyone have non-Simplicity numbers for the BGB seals?  I have had a couple of BGB's with incorrect seals. They were correct ID but too small OD and leaked around the outside of the seal without the seal spinning.  I always RTV the seals now.

Share this post


Link to post
Share on other sites
Chris727
On 10/10/2018 at 12:18 PM, CarlH said:

Does anyone have non-Simplicity numbers for the BGB seals?  I have had a couple of BGB's with incorrect seals. They were correct ID but too small OD and leaked around the outside of the seal without the seal spinning.  I always RTV the seals now.

So far I've never run into that. All of my FDT right hand seals fit snugly or were tight enough to be difficult to remove. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Who's Online (See full list)

    • Bill725
    • rokon2813
    • PhanDad
    • bvande
    • mikeman
  • Today's Birthdays

    1. littlefan
      littlefan
      (60 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      Paul
       
      · 9 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts

×