Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
DarrellL

broken rear axle housing

Recommended Posts

DarrellL
I have a broken right rear axle housing on a 718h allis. Could anyone tell me what too expect if I start to tear it apart, or if I should try to replace it? I am a millrite by trade and think I can rebuild it. I would just like to know what to expect. Also where can I get a service manual for a 718h model? I can be reached at lamb1@mtco.com. All imfo would be axcepted with joy(except bad news). thanks DarrellL

Share this post


Link to post
Share on other sites
MikeES
The housing is cast iron, and if it is cracked or broke you probably need a replacement. I cannot picture any way to break the housing unless you broke and axle tube. The needle bearing and seal will probably be shot. But more than likely everything else is OK. Be careful when taking apart as there are spacer washers and must go back in the correct order. Good Luck! Mike S.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×