4041 rear PTO no GO

[Gcabinet1]

Hi guys the rear PTO on my 4041 stop working

 I am  getting power at the clutch ,winding seam intact ,some of the surface epoxy has come out  

Are these still available or does someone on the site repair them?

thanks for your help in advance 

Gary

[jlasater]

Did you check resistance across the windings with it unplugged?

[Gcabinet1]

No , “I only know enough about electrical stuff 

to be dangerous!”

How do I check that?

 Thanks 

[Gcabinet1]

Should I have continuity across the plug?

[PhanDad]

If there’s 2 leads coming from the clutch, check the resistance between them.  Should be at least a few ohms.  Maybe someone here knows the spec.  Also check each lead to ground - that reading should be infinite.  

If there’s only 1 lead, then measure the resistance to ground (other “lead” is already grounded).  

 

[Gcabinet1]

ok Thanks Bill

[720nut]

Contact Mike Noonan or Mike Brown they know someone who rewinds the clutches

[Gcabinet1]

Thanks I’ll do that

[Brettw]

I am not sure how that clutch is set up, but if it can be adjusted you might want to check the clearances on the clutch?  I have seen cleaned up connections and adjusted clearances make them work well again.  Just a thought.