Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

4041 rear PTO no GO


Gcabinet1

Recommended Posts

Hi guys the rear PTO on my 4041 stop working

 I am  getting power at the clutch ,winding seam intact ,some of the surface epoxy has come out ! 

Are these still available or does someone on the site repair them?

thanks for your help in advance 

Gary

Link to comment
Share on other sites

No , “I only know enough about electrical stuff 

to be dangerous!”

How do I check that?

 Thanks 

Link to comment
Share on other sites

If there’s 2 leads coming from the clutch, check the resistance between them.  Should be at least a few ohms.  Maybe someone here knows the spec.  Also check each lead to ground - that reading should be infinite.  

If there’s only 1 lead, then measure the resistance to ground (other “lead” is already grounded).  

 

Link to comment
Share on other sites

I am not sure how that clutch is set up, but if it can be adjusted you might want to check the clearances on the clutch?  I have seen cleaned up connections and adjusted clearances make them work well again.  Just a thought.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...