Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
UCD

Single point hitch diagram

Recommended Posts

UCD
Need a diagram or single point hitch rear lift hook up. I have searched the site and can't seam to find one. Basicaly what i need is routeing for cable and pully instalation. Thanks This & $1.00 might get you a small coffee (hopefuly me a diagram) Maynard aka/UCD

Share this post


Link to post
Share on other sites
Dutch
Maynard, Sorry, don't have a diagram, but installation is straight forward. Pulley mounts exactly like the mower deck pulley on 2 similar ears on the other side of driveshaft. Look under tractor, you'll see the ears. Cable goes through frame tunnel (where BGB is located). Through the pulley, over the lift cross shaft, and attaches with a pin. Take a look at lower photo for routing behind BGB and attachment to lift. http://home.att.net/~herb.niewender/drive.jpg

Share this post


Link to post
Share on other sites
UCD
Dutch Thanks I got it in. Alot of fun on your back with no room to move and could use only one hand to hold a pully a bushing cable guard and a nut but i did it. This & $1.00 might get you a small coffee Maynard aka/UCD

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×