Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

  • 0

Attention Simplicity 725 Gurus?


dince

Question

A question about the rear wheels on my 725.  The IPM shows a plug (part number 152042) held in with a hub bolt.  Are there actually two of these?  There two threaded holes in the hub, as are there two in the left hand hub (two set screws in there?).

What is the plug made of?  What do folk use for replacements?  Could I use nylon bearing stock?  I presume they fit freely in the stud hole, but how long are they?

Any information, or suggestions will be greatly appreciated.  Thank you.

Edited by dince
Link to comment
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

×
×
  • Create New...