Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  


Recommended Posts

anybody know the correct belt length for the revitalizer. in the belt section it says that it takes a 96.1 belt length for a 7100 series. I have it on my B212 which is the same as the 3212. the revitalizer is MFG. NO. 990688 in the what fits section it says that this is the right revitalizer for the 3212 but I have`nt been able to find the belt length. I was just wondering if they would be the same length. With the revitalizer disengaged there seems to be 2 inches of belt in front of the pulley on the bevel gear box. the pulley thats on the bevel gear box is the same one that I use for vaccum system that I have. would these pulleys be the same size. thanks for the help ray

Share this post

Link to post
Share on other sites
From the info in my belt book it should be the same belt as the rototiller belt #105340. Same # in the revitalizer parts manual. It is a 96.1 inch belt. HB cross section 21/32"wide 7/16" thick. Go to this site http://www.simplicitytechpubs.com/techpubsearch.php The link is below, and insert( 990688 ) you can download the owners and parts manual both downloads are the same if it fails try again. I had to do it 3 times. This & $1.00 might get you a small coffee Maynard aka/UCD[A href='http://www.simplicitytechpubs.com/techpubsearch.php']http://www.simplicitytechpubs.com/techpubsearch.php[/a]

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • kwt
    • SmilinSam
    • 720nut
    • MARK (LI)
    • B-1 Bryan
    • BLT
    • deebig
    • CarlH
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
      · 1 reply
  • Adverts