Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
srwven

CADloader information

Recommended Posts

srwven
I saw an ad for a Cadloader LT model 507 that is currently on a Massey MF12. I know these are kits built by the buyer. Does anyone have any info on these? I am wondering if this would work for my 7014. Any help would be appreciated.

Share this post


Link to post
Share on other sites
Kent
I have no firsthand experience with this loader... so take this with a grain of salt. 1) It could likely be modified to fit by building a custom subframe to fit your tractor.... 2) Don't forget to somehow reinforce or spread the stress away from the bevel gear box -- the entire rear end of a Simplicity is attached by 4 bolts holding the front of the bevel gear box to the frame... If you don't somehow spread the stress, it could literally break your tractor. 3) I'm not a fan of this particular loader for a couple of reasons. (a) it uses only one lift arm and cylinder which would have to put a twisting force on the tractor frame, and (b) it is a relatively weak loader, lifting only 200 lbs to full height... in comparison the L-12 lifted 300 lbs, and some other kits will theoretically lift 500 lbs -- though I wouldn't recommend it.... Again, I have NO experience with this loader... my opinions only....[A href='http://cadplans.com/507.htm']http://cadplans.com/507.htm[/a]

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×