7016h snow thrower.

[mbinwi]

Happy Halloween!

The snow thrower I have is 34"  I'm going to make extra "wings" for each side so it covers the width of the tractor.  I assumed it was a 36", until I actually measured it today, duh!

Trying to figure out the drive belt I need.  The clutch/driver is on the front of the motor.  There is no label or sticker under the hood, and the label that was on the snow blower, with the model number is gone.

Any ideas?

Thanks,

Mike.

[dhoadley]

Picture would help others. I don't anything, and don't even suspect very much. 

[PhanDad]

19 hours ago, mbinwi said:

The snow thrower I have is 34"

If it is actually 34", I doubt it's OEM.  I've had "36" inch blowers in the past and they all measured 36" +/- 1/4" or so.  

As @dhoadley stated, pics would help.  

If it is a Simplicity Blower, then this IPL for a MFG# 990745/6 blower:

shows the belt needed for the front mechanical PTO with 2 pulley hitch.  

 

[mbinwi]

Thanks PhanDad, I'm an idiot, I measured wrong.  It is a 36".  The blower is partially buried in my shed, so I drug it out and measured  again.

Did some searching around, and with the help from a member of the ST facebook page,  I have the 1690033 model.  

Mike.

[BAP]

18 hours ago, mbinwi said:

Thanks PhanDad, I'm an idiot, I measured wrong.  It is a 36".  The blower is partially buried in my shed, so I drug it out and measured  again.

Did some searching around, and with the help from a member of the ST facebook page,  I have the 1690033 model.  

Mike.

Your not an idiot, you were just using that new fangled math to measure with the first time