Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
mbrook

4211 steering wheel

Recommended Posts

mbrook
I have a Simplicity 4211 that the shaft for the steering wheel broke just below the nut that holds the wheel on. The steering wheel does stay on but is a little lose. Is there any idea on how to fix this? Would a bolt through the bottom of the steering wheel and through the flat section of the steering shaft work? Or would that cause the steering wheel to crack. Any suggestions would be appreciated.

Share this post


Link to post
Share on other sites
lsenus
I've included links to the manuals for the 4200 Gear & Hydro tractors. I would definetly replace the part. Hydro trans tractor http://www.simplicitytechpubs.com/6767PRINT/PDF_files/TP_400_1094_03_LT_S.pdf Manual trans tractor http://www.simplicitytechpubs.com/6767PRINT/PDF_files/TP_400_1095_04_RG_S.pdf

Share this post


Link to post
Share on other sites
KSever
When I purchased my 4111 it had the same thing wrong with it. I sawed the shaft off so it was nice and smooth then drilled down through the shaft approximately 1 1/2". Then tapped a new hole and installed a new bolt. Just like new and not a problem since.

Share this post


Link to post
Share on other sites
JeffNemes
I have also tapped them with success - 1/4" threaded rod with locktite works well. Neverseize the nut for easy future removal and use a flat washer and lockwasher.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • victorsnc
    • Sovereignm88
    • Ronald Hribar
  • Today's Birthdays

    1. r32ford
      r32ford
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×