Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

A/C 716 attachment options


doogie_ac61358

Recommended Posts

Does anyone out there know how to make a one bottome plow for the 716, and also does anyone know how to make a bucket for the front of the tractor. I am working w/a tractor that was given to me and currently have done some modification to it. I am looking at making a regular front end loader for it and could use any thoughts, suggestions, drawings, or anything you have to say for assistance. Doug Freeman "Angel from above"
Link to comment
Share on other sites

Don't know what you mean by "make" a plow, but a plow with a sleeve hitch will connect right up to a 716. Check this out > http://www.simpletractors.com/models/700_series/10_plow.htm As for a loader, check this out > http://www.simpletractors.com/parts/l-12/l-12_loader.htm Also check the "Johnny Bucket" > http://www.simpletractors.com/sponsors/johnny_products.htm
Link to comment
Share on other sites

Your simplest solution on the plow is to buy a Brinley. I'd get a 10" for your 716, although there is an 8". Used will be $75 or so. Then comes the hard part. If your lucky, your 716 has the rear lift kit on it. If not you'll have to locate one. Then you need the hitch from the plow to the tractor. They don't sell these new anymore, but can piece together from parts. But be prepaired to get out your checkbook if you go that route. I was quoted $165. I lucked out on E-bay for $35. Good luck!
Link to comment
Share on other sites

You might just find one, like this one that was sitting on the curb. The tiller and Serf in the pic show the size of this bad boy.... HEY PAUL!!!!! You can have this one for free instead of making a two-bottom rig.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...