john 0 Posted September 8, 1999 It seems that when I attempted to replace the transmission fluid in my Simplicity Regent Hydro, the Hydrostatic Tuff Torq K56 transmission refused to accept all I had to offer. To be honest, I did not know the transmission capacity until I discovered the Simple Tractor site. I just felt like more fluid came out of the transmission than went back in. I followed the manual instructions to the letter but now find that I must get another 32 ozs in that thing. Can anyone offer any tricks or solutions. The dealer just said to drive it back and forth a few times, then recheck the fluid. But, that requires a little work; removing the battery again and trying to pry up that seal. Of course I know that I have to do that now, but how do you really change the transmission fluid so that it is a one time chore? Also, I noticed what seemed to be a filter underneath the spring, however the owners manual does not mention it. Could this have prevented the fluid from draining into the right side fast enough that I just assumed the thing was full. Anyway, if there is a filter there, when should I replace the thing? Thanks Share this post Link to post Share on other sites
AdamF 0 Posted September 10, 1999 Steve, I'm not familiar with that type of hydro BUT it has to have a vent plug on it somewhere so you can put the rest of the fluid in.What you have to do is contact Jeff Nemes,he would[or should!] know where the vent plug is.You have to let the air out of the system while filling the resevoir or you'll be 2 yrs. getting all the oil in!Jeff's a knowledgable fellow and don't even bite! dlc Share this post Link to post Share on other sites
Kent 435 Posted September 17, 1999 Well, finally got in touch with the manufactor and they said I should have removed the filter. The owner's manual made no mention of this. It seems that the new oil did not flow through the filter fast enough, so the oil reached the full indicator without the tranmission really being full. Thanks for the reply. Steve Share this post Link to post Share on other sites
Kent 435 Posted October 2, 1999 Simplicity has issued a service bulletin regarding this - see the link below:[A href='http://home.att.net/~jnem/pics/99-19-PurgingTuffTorq.jpeg']http://home.att.net/~jnem/pics/99-19-PurgingTuffTorq.jpeg[/a] Share this post Link to post Share on other sites