Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors


Motor conversion kit for 9020 tractor

Recommended Posts

Well it looks as though the motor in my simp 9020 wont make it another season. There was a outfit advertizing a motor conversion kit to replace the factory Onan on the the club's site. Anyone recall this web site? Has anyone made this change to a tractor and how did it work? Thanks Russ. clark_rc@hotmail.com

Share this post

Link to post
Share on other sites
Russ, the outfit that was advertising the engine conversion kit for the 9020 was Small Engine Warehouse. There is a link on the home page of this site. From other members that have tried the conversion, there has been mostly positive comments though several "glitches / could be better" problems with it however minor.

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.

  • Who's Online (See full list)

    • rbstuartjr
    • newellhvac
    • gwiseman
    • MARK (LI)
    • SmilinSam
    • GregB
    • MRR
    • PhanDad
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts