Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

JFS

Bracket for Electric lift

Recommended Posts

JFS
Does anyone have the specs on the bracket that holds the electric lift for an AC 710? I've search the site and can't seem to locate any info on it. I'm told it's no longer available from the manufacturer.^ Thanks John

Share this post


Link to post
Share on other sites
MikeES
The last I checked (about 1 year ago) all the parts are still available for the electric lift. It is no longer available as a kit. I just know to buy it in parts would exceed $300. If the bracket is not, you may need to "borrow" one and copy it. I think a member has done this already.

Share this post


Link to post
Share on other sites
Dutch
Even though these brackets are simple, it would be quite an effort to draw 3D blueprints showing the subtle angles and curves. As Mike suggested above, it would probably be easier if you borrowed one and copied it. I have one I can lend you if you want to pay the shipping costs. It may be easier (and cheaper) to place an ad and buy one from a parts tractor. [img]http://www.simpletractors.com/club2/attach/thedaddycat/Dcp02316.jpg[/img]

Share this post


Link to post
Share on other sites
JFS
Thanks for the offer Dutch. I took your advice and puchased an actuator and bracket from a club member. Hope to see it soon, that roto tiller is getting heavier with that manual lift each time I use it. Thanks to all who replied. ^ John

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Who's Online (See full list)

    • NickDanyleiko
    • B10Dave
    • RollenBones
  • Today's Birthdays

    1. 9934059
      9934059
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×