Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
whabadoo

Belt and Blade specs, AC BigTen 42" Deck

Recommended Posts

UCD
2025061 BIG-10 Drive Belt............ Part# 154273 .. Note * Units with Low Speed Pulley use Belt# 174486 Generator Belt..... Part# 1607323 P.T.O. Belt........... Part# 164146 Power Lift Belt..... Part# 157230 990407 42" Rotary Mower Cross Drive Belt... Part# 174911 Arbor Drive Belt... Part# 1719819 Blades................ Part# 1656144 qty 3

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • bowhunt4life
    • NickC.
    • PGL
    • MARK (LI)
    • gwiseman
    • SmilinSam
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×