Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

stinkie

New Engine Questions

Recommended Posts

stinkie
I am trying to find a replacment engine for my 243431 0123 B&S 10hp engine in a 66 landlord 101. Any brand of engine would do (I prefer a kohler) but I would like to upgrade to a 12 or 14hp. I contacted B&S and there is no replacement for the 243431. I would assume that a 12 hp motor from a later model landlord would work (assuming that they all have the same mounts and shaft height). Could anyone give me some info on the model #'s for these 12hp engines from the newer tractors so I can try to get a kohler replacement? Or ANY info at this point would be great. Thanks stinkie

Share this post


Link to post
Share on other sites
Dutch
In later years, the Landlords used both the B&S and Kohler K-series. http://www.simpletractors.com/parts/engine/landlord.htm I would assume your 10hp B&S could be replaced by a 14hp Kohler with very little modification.

Share this post


Link to post
Share on other sites
DonNewberry
The small engine warehouse has a 16 h. b&s motor available. It's #326431. However, It's awful expensive if you're not planning on using the tractor for years to come.Don

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    1. rokon2813
      rokon2813
      (55 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×