Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
dieselman

Bevel Gear box oil

Recommended Posts

Dave-Saratoga
the multi-purpose fluid is recommended by the manufaturer. the "heaviness" of an oil is not important. hyraulic oil used in older trannies & gearboxes is much lighter than 80/90. the question is one of lubrication & colling. i'd go with the manufaturer's recommended fluid

Share this post


Link to post
Share on other sites
country
I bought the Simplicity oil for mine. I still have to get a filter before I change it. I trust the multipurpose oil due to some knowledge of John Deere tractors. When I worked on the farm in high school and early college the John Deere tractors they used were 70's vintage. The hydraulic oil that ran the three point hitch and external hydraulic outlets was the same oil used to lub the complete rearend of the tractor. That's right, the entire rearend, tranny and hydraulics all used the same lot of oil. About 10 gallons if I remember right. So, considering those JD tractors were used very heavily doing much more strenous work as compared to my garden tractor, I have no worries about using the Simplicity multipurpose oil. Just my $0.02.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • B10Dave
    • PhanDad
    • AC710
    • mattcuccia
    • MrSteele
    • NateShedivy
  • Today's Birthdays

    1. dbulkley62
      dbulkley62
      (59 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×