Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
samson

B10 seat @ arm rests

Recommended Posts

UCD
There are 3 places you can get them from Mary Gearhart aka Yellowbee kmgeartheart@juno.com here is a copy of an email Mary just sent me I make new cushions. I use new plywood; new t fasteners; new dense foam and new heat pleated vinyl. The set is $80 + $10 shipping. The set includes the bottom, the back, and armrests. They are made with heat pleated material, white on top and smooth vinyl on the sides. These seats will fit the AC B-1, AC B-10, Big Ten, AC B-110, AC B112. You can send a check or money order to: you can all so order from [url="http://www.wellsimplement.com/lawn.htm"]Wells Implement[/url] Smooth Vinyl Or [url="http://www.sandylakeimp.com"]Sandy Lake Implement[/url] Heat Pleated Or Sewn Pleated

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • simplewrench
    • Chris727
    • PhanDad
    • DaveBsACs
    • AC710
    • MRR
    • MARK (LI)
  • Today's Birthdays

    1. Chris727
      Chris727
      (36 years old)
    2. jdwilson
      jdwilson
      (64 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×