Tiller Fit question

[JohnInMI]

I have a 2110 Landlord and found a 32" tiller at my local dealer. He stated that it was for a broadmoor and probably wouldn't fit my tractor without some modifications. The tiller is a 990174, when I check the what fits page it says to look at a 990392, when I look there it shows that it would fit the 2110. I looked up the manual and it looks like it will fit my mower. There are two problems though. I don't think the tiller has clutch lever assembly and pulley with it and I don't have a rear lift assembly (could make one, but I also need the shaft). So my question is do you guys think the 990174 will fit the 2110? Anyone have an extra PTO assembly they want to part with?

[Bunky]

Not sure If the tiller would work or not.. But good luck on the Tiller Drive.. I tried to find one for an extra Allis Tiller I have.. They are hard to come By DLC had one for $125 not sure if he has it or not... I just went out and bought a 2010 with a tiller and other attachmnets for $200....

[mowerman1193]

Yes the 990174 fits the 2110.That tiller is not for a Broadmoor if its a 32in.The Broadmoors did not have that big of tiller. Like Bunky said the tiller drive system is hard to come by and they are not cheap.

[JohnInMI]

Thanks guys. I'll check to see if the PTO assembly was on there. For the life of me I don't remember. I'm guessing it wasn't. DLC already sold his. :( Mowerman I see from your gallery that you have a very similar tiller (if not the same one). I was in your neck of the woods a month or two ago. The Olivet high school FFA put on a farm toy show. I was looking for a pedal tractor for my daughter, but didn't find one. Found a few 1/64 scale tractors though.