Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

petef

B-112 Transmission

Recommended Posts

petef
Hi guys, I haven't been on the list in almost a year so I hope I.'m not repeating a recent discussion. I have a B-112 that has the dreaded worn transmission disease ( I think). It will no longer stay in reverse, it has to be held there, and it is getting harder to get it into any of the other three gears. I know it is no little job to replace this trans!! Does anyone know if the gears can be replaced or am I looking at custom made replacements or total trans swap?

Share this post


Link to post
Share on other sites
Stoneheartfarm
Parts should be available. I had to change a couple of gears in mine a few years ago and with 2 bearings, the bill was about $200.00 for parts. Construction is fairly straight forward, and if you mark the parts as they come off so that you know which part goes where, it should be no problem. The hardest part is dragging the axle around after you get it off. Steve

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Who's Online (See full list)

    • dhoadley
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×